Polygon Upright Microscope Installation

1. Carefully remove the trinocular head from your microscope. For detailed instructions, please refer to the vendor’s manual for your microscope.

2. Mount the beam splitter cube or 3-position adaptor to the top of the microscope frame, usually above the filter wheel, if one is present. Use an allen key to tighten the adaptor set screws to hold it in place. Insert the trinocular head back on top the cube and tighten the set screws. Carefully insert the Polygon400 all the way into the cube and tighten the set screw found in the cube using a 3mm allen key.

Note: The above diagram shows an example installation with a cube adaptor. If you purchased a 3-position adaptor it will be installed following the same instructions.

See below for installation video.